Pince de levage CD avec certificat CE
1) Before and after each use, check all parts for abnormal conditions, such as cracks in the welding seam of the clamp body. Deformation of holes or shafts and scratches on rotating parts. Rust and damaged jaws, etc.
2) After the label is lost, it should be replaced in time to avoid incorrect use.
3) The wrong storage place should prevent rust and damage to the painted surface of the cross clamp.
4) When not in use for a long time, grease should be applied to all movable parts, and the area parts should be painted.
5) The user is not allowed to change the structure of the vertical clamp at will.
Description du produit
Information produit:
Application:Levage vertical de tôles d'acier.
Plage de chargement:0-12 tonne
Un morceau de pince est utilisé pour le test,et une pièce ou 2 pièces sont recommandées pour les opérations de levage.
Les plaques multiples ne peuvent pas être soulevées,ne soulevez qu'un seul morceau de pince une fois. Relevez le levier de verrouillage pour serrer le ressort de verrouillage lorsqu'il est sous chargement. Abaissez le levier de verrouillage pour desserrer le ressort de verrouillage,quand tu pourrais décharger.
L'objet chargé ne doit toucher à rien lors de l'utilisation. Le chargement excessif est interdit. Lors de l'utilisation,la surcharge est interdite.
La charge testée est 2 temps de charge de travail.
Avec ressort de verrouillage pendant la condition de non-travail de la pince,dispositif de verrouillage va dans la nature step-up,mettre l'objet dans la pince,la force devient l'amélioration de la proportion.
Résistant,opération facile.
Precautions
-Only one steel plate can be lifted by vertical lifting at a time.
-The following situations are prohibited during use.
(1) If there is a serious tilt after lifting the steel plate, the lifting clamp should be re installed.
(2) The steel plate does not reach the bottom of the vertical clamp when the clamp is installed, so that only part of the steel plate is stuck by the vertical clamp after lifting the steel plate.
-During the lifting process, the steel plate that is forbidden to be lifted is subject to collision and impact.
-The lifting process should be as stable as possible, and it is strictly forbidden to stand underneath or pass over objects.
-The surface hardness of the suspended steel plate shall not be greater than HB220. Vertical clamps are not suitable for hoisting stainless steel plates. 10) No oil stains are allowed on the surface of the hoisted part of the steel plate.
scrapped
When one of the following situations occurs, the parts should be replaced or scrapped
1) When the wear height of the jaws and the support platform reaches 10% of the original height;
2) When two teeth are chipped or broken;
3) When the wear of the clamp shaft reaches 25% of the original diameter;
4) When the pliers shaft or pliers body deforms to 1.5% of the original size;
5) The overall movement of the horizontal clamp is not flexible, and it is still not flexible after adding lubricating oil to each sliding part.